Team-Xecuter Community
Just soldered in the QSB to a trinity , have done a previous RGH but with wire install and diy nand reader, decided to go QSB this time to make things easier and all i'm getting when i hook up the jr-programmer and try and read the nand is Flash Config: 0x00000000 , double checked all the soldering , all points have good continuity between the qsb and the points (checked on the underside to make sure i wasn't getting a reading from the qsb , and good continuity between the wires to the jr-programmer and the points / qsb , no shorts and obviously board is in the metal cage and hooked up to the power brick but not turned on.
Have i missed something, i just want to read the nand before i hook the CR3 lite up but i'm getting nothing
Ps if pic isn't good enough i will try and get hold of a camera instead of using my phone
Have i missed something, i just want to read the nand before i hook the CR3 lite up but i'm getting nothing
Ps if pic isn't good enough i will try and get hold of a camera instead of using my phone