RGH Green LED flashes around 6 times and stops...

ppkpatrick

VIP Member
Dec 16, 2010
313
33
Ireland
Green LED flashes around 6 times and stops... UPDATED: HQ pics

So I got everything installed on my Zephyr Dash 14719 and went ahead and booted my console (everything done installed hardware,wrote .ecc built with the new files,flashed coolrunner,etc) and when i turn the console on the green LED flashes about 6 times and then it stops and when i reboot the Green LED doesn't flash at all!! unless i unplug the power.Need a little help on this one.There is a bad block on my nand but it's at 178.Orig nand is perfect as i re-flashed and it booted fine.

(BTW. using xecuter lpt cable to flash coolrunner
and lpt cable to read/write nand)

STBY_CLK: http://imageshack.us/f/69/img3336o.jpg/

*Updated with HQ pics,sorry for delay, been busy.
Note: LPT cable has since been removed.
 
Last edited:

ppkpatrick

VIP Member
Dec 16, 2010
313
33
Ireland
sorry havn't posted since that rule was introduced,I'll have them up in 2 mins
 

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
Chech your video cable, are you using HDMI or normal cable?
 

poisins

VIP Member
Mar 3, 2011
164
0
Alūksne, Latvia
Looking at pics, seems you have used RGH2 install diagram.

You don't need A point (green wire). Just solder 2 wires under board - blue and yellow