RGH Green LED Won't Flash on CR

[iMoses]

Jasper 6751 W/ 360 multibuilder donor 6750
Alternate stby_clk
Tried a different CR and still no flash

 

[BL4K3Y]

Did you program the CoolRunner with the relevant Jasper XSVF/JED?

 

[iMoses]

Did you program the CoolRunner with the relevant Jasper XSVF/JED?

Of course. Both of them were programmed.

 

[BL4K3Y]

Re-solder this point, there looks to be a small bridge between the pad and the resistor above it.

 

[sinn78]

Re-solder this point, there looks to be a small bridge between the pad and the resistor above it.

wow i been reading here a lot and looking at pics and let me tell you you are good i didnt notice that at first look keep up the great work boss :wink:

 

[iMoses]

Re-solder this point, there looks to be a small bridge between the pad and the resistor above it.

The .ecc was bad. I tried a 6750 .ecc from another 256 RGH I have and it worked perfectly. Thanks for the help, though.

 

[BL4K3Y]

Let me know how you get on, I can't say for certain if it is a bridge without seeing the actual board but it looks like one.

 

[iMoses]

wow i been reading here a lot and looking at pics and let me tell you you are good i didnt notice that at first look keep up the great work boss :wink:

There was no bridge, it's simply glare from the flux and light. I used isopropyl alcohol and cleaned the area and it works fine.

 

[BL4K3Y]

Which version of 360 Multi Builder did you use?

 

[iMoses]

Which version of 360 Multi Builder did you use?

v0.3, which I just read has a bug with 6751... which figures why the 6750 CB worked fine... Dammit :facepalm:

 

[BL4K3Y]

Use the latest version (v0.4), it fixed some issues with Jaspers I believe .

 

[iMoses]

Use the latest version (v0.4), it fixed some issues with Jaspers I believe .

I will in the future, no point anymore haha. Thank's for the suggestions.