I bought the sx pro. Then find out my switch card reader is defective. so i bought a new switch and a new license for os. But the new switch is patched so i have to wait a while, which i dont mind, but just wondering when you guys able to crack the new switches, are you going to release a new dongle and new os or just an update. Really dont want to buy everything again if possible. Thanks.
Now I've been waiting for a month and was wondering, will the upcoming 2.0 version deliver a solution for the patched switches? I know it's TBD, but it was said that the solution is being worked on and also that there's progress, and I would just like some reassurance or something. For example whether the sx pro dongle will even work anymore or do I sell it, or will there be a new implementation of it of some kind? I'm asking because, sadly, buying an older switch is not a solution for me and I would like to refrain from buying anything else that might or might not come in the future.
I don't have try that, but on my switch is not possible at the moment with the pro dongle i hope with os firmware v.2. I want to use the dongle and sx os because I've the license on that. I've see that the jig use two pin but there's other versions of the jig on internet that not use the same pins. I want to try to use this alternative jig for go in recovery mode, but I'm not sure if is possible do inject the sx os, can be an alternative.
FYI - I didn't see this until after I purchased SX PRO. I have downloaded and installed the SX OS 1.9 version. I have XAW40008 and did have issues when I tried to do a request/activate the license (basically crashed and then had to power down), but I was able to get it to boot, so I took the license request off the micro SD, manually activated and then I was able to boot the custom rom. I have been able to use the INSTALLER. So far the only issue I have noticed is using some homebrew app. I will report if I have any other issues.