I'm talking about CPU_RST point to FT3T10
I hear alot about it for coolrunner
just wondering if it is usable for the dgx cpu reset
I hear alot about it for coolrunner
just wondering if it is usable for the dgx cpu reset
DGX has anyone tried the alternative cpu rst for dgx?
- Thread starter joker2009
- Start date
On Corona consoles, CPU_RST shouldn't be much of an issue.
I suggest you try a 10CM wire on C5R11.
I suggest you try a 10CM wire on C5R11.
Yes, but why would you?
You stand more chance of pulling the pad because it's a lot smaller and more fragile than C5R11.
You stand more chance of pulling the pad because it's a lot smaller and more fragile than C5R11.
jligg
VIP Member
Probably cause c5r11 makes you remove the xclamp. For dgx the c5r11 point seems to be the best. Pretty much instant boot if you cut that wire as short as possible. Every corona I done booted on first pulse
Sent from my ADR6400L using Tapatalk 2
I cut it to 10cm and soldered it to c5r11
now backing up nand and then writing the dgx to nand
quick question, when i boot the xbox to get cpu do i unhook the nand wires from jr programmer or do i keep them plugged in?
Disconnect your J-R Programmer from the console before powering the console on.
I've helped you with the basics.
It's down to you to read guides and learn what to do next
.Now i know why my dgx hasnt been glitching then
I have alsways left the jr programmer connected
jligg
VIP Member
nothing
the dgx has a red led and the console doesnt glitch
unfortanitly i had the dgx plugged into the jr programmer when i booted it until blakley said to disconnect it so i hoping i didnt screw it up
i tried to post pics but i keep getting upload fail or a security ke mismatch