have a problem

B

BLACKBIRDxx

Full Member
Jul 1, 2005
34
0
san jose ca
i ftp ed a new x3cl screen to the xbox and it locked up. i rebooted and it will not get passed the rox my box screen. i am able to get to the flashbios screen with the banks set to off on off off. i have a 1.6b version and the 3.03 bios is on this bank so i tried to flash the 3.03 to the other 1mg bank off off on on so i would have a back up if anything goes wrong. well the xbox shuts off right after the green bar finishes. what is the next step to make sure i dont lose the the 3.03 flashbios and still be able to get to the x3cl control panel? thanks for any help.
 
B

BLACKBIRDxx

Full Member
Jul 1, 2005
34
0
san jose ca
actually islander, i had the bank switches set right and typed it in wrong in the post. the flashing was working correctly, also (if i had read the ftp flashbios instruction it says it shuts off the xbox automatically after the flash) what i needed was the 3294 bios not the stock one to get it to boot to the x3cl dash. i was so frustrated when it happened i didnt pay enough attention to what i was doing. anyways i flashed the 3294 back to the chip and bingo! the x3cl dash booted up fine. dodged a bullit there. thanks also for your help.
kirk
 
Last edited:
You must log in or register to reply here.