OK...
Using a USB PRO to try to update my firmware.
I have my keyfile dummy.bin, I load that, JF autoloads LT Plus 1.9 for my Lite-on 7xxx series drive.
I click Erase Lite-on, it does it things, I hit the reset on my Xecuter CK3, it goes into vendor mode. OK all is good, until I hit "write".
EVERY TIME, it hangs like this:
Sending Chip Erase to Port 0x0000
Erasing:
Then JF said, Not Responding.
Now after about a dozen tries, I finally got it to do this:
Sending Chip Erase to Port 0x0000
Erasing:
Writing target buffer to flash
Writing Bank 0: .XECUTER X360USB PRO removed.
Then it said, Not Responding again.
As far as my USB PRO goes, I've got the firmware .18 update. I've got the newest drivers you guys have listed and I'm also using the newest JF, Beta 250.
Where should I be looking next? I've been messing with this for like 5 hours now, same results every time.
Using a USB PRO to try to update my firmware.
I have my keyfile dummy.bin, I load that, JF autoloads LT Plus 1.9 for my Lite-on 7xxx series drive.
I click Erase Lite-on, it does it things, I hit the reset on my Xecuter CK3, it goes into vendor mode. OK all is good, until I hit "write".
EVERY TIME, it hangs like this:
Sending Chip Erase to Port 0x0000
Erasing:
Then JF said, Not Responding.
Now after about a dozen tries, I finally got it to do this:
Sending Chip Erase to Port 0x0000
Erasing:
Writing target buffer to flash
Writing Bank 0: .XECUTER X360USB PRO removed.
Then it said, Not Responding again.
As far as my USB PRO goes, I've got the firmware .18 update. I've got the newest drivers you guys have listed and I'm also using the newest JF, Beta 250.
Where should I be looking next? I've been messing with this for like 5 hours now, same results every time.