Having trouble with jtag bad block info

[scarface1]

ok im a bit confused on this sorry kinda knew to this was reading all the guides that i seen on here that are very good detail but this is were i am stuck at. Both my dumps show no differences but have the same bad block of course.

They say you have to remap the bad block if its under 0x0050.

OK so my bad block id 0x02B0 falls into this correct?
If so on the remapping it says to open up NandPro well when i do that it just closes really fast or do i still just use the regular cmd that i was using when i dumped the nand. And just follow the guide like stated for remapping? so would it be like Nandpro nandecc.bin: -r16 bb1.bin 2B0 1 to extract it? then what do i do with the extracted one? sorry on this questions just a little confused at this point here. I have not tried to remap it yet because of the nandpro cmd closing right away and i wanted to make sure if i had to or not.

Thanks all for the help.

 

[manwithoutname]

You have to run nandpro in the cmd mode. Out of interest, are you doing a Jtag or RGH install? If doing the RGH try without remapping the blocks first and see what that yield.

You need to load your original nand dump into 360 flash dump tool to see where the bad block is mean to be under the bad blocks tab.

 

[scarface1]

You have to run nandpro in the cmd mode. Out of interest, are you doing a Jtag or RGH install? If doing the RGH try without remapping the blocks first and see what that yield.

I am doing the RGH and will do after i wake up today just got off work and did that up really quick thanks and will post back when i get up and try without it.

I was just following Fib3rs guide to it which is well detailed but i just did not get that part so thanks again ill go from there and see what happens


Edit for manwithoutname
You need to load your original nand dump into 360 flash dump tool to see where the bad block is mean to be under the bad blocks tab.
Bad Block ID 0x02B0 [offset: 0x00B16000]
Block ID 0x02b0 found @ 0x3FF [offset:0x0107BE00]

Analyzed Successfully



Edit:: UPDATE:: well got it to boot xell and right now going to flash the stuff over at the very end of the tutorial my question is with that freeboot 2.2 that is out does that go onto a flash stick to install it or how does that work if anyone knows thanks.

 

[scarface1]

Well i got everything up and running great thanks for the help with the question i had asked.

Just another quick question if its booting the dash is it freeboot then or do i still have to install it if so where do i get the info on how to do that