LITEON DG-16D4S - SLIM Having trouble with my 2nd kamikaze hack

R

RED 1

Full Member
Nov 1, 2011
31
0
UK
Hi all,

I followed the JF/dubbs guides and completed my 1st kamikaze hack. All went 100% fine.

I am now doing my 2nd kamikaze hack but I am having trouble straight after I write the firmware, it fails shortly after during the verification process. I am using a dremmel/via card/ck3 (as I did the first time)

The dremmel unlocking process again went fine with a nice unlocking 0x00 beep but for some reason its not completely writing the firmware this time?

ANY ideas would be greatly appreciated

Thanks
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
There is no kamikaze support here. I suggest you try other forums.

Get your dummy.bin and replace the PCB, writing a new firmware based the dummy.bin you got from the drive.
 
R

RED 1

Full Member
Nov 1, 2011
31
0
UK
Iv tried Mod Traders and Mr Modchips but both are sold out of replacement boards with no date for new stock. Would you recommend ebay or any other sites?

Thanks
 
R

RED 1

Full Member
Nov 1, 2011
31
0
UK
Thanks for the advice. Would I get a warning from Martin C if I did?
 
R

RED 1

Full Member
Nov 1, 2011
31
0
UK
Just the mods?
 
D

draco31

Junior Member
Dec 29, 2012
20
0
california,usa
vgcrepairs they sell and have in stock i bought my tx pcb from them

edit: i take that back i just check and they are sold out too sorry.
 
Last edited:
You must log in or register to reply here.