Header is wrong??

[morinzo]

I had a customer bring me a Jasper 512mb rgh2 with a clone cr3 and he want's me to replace the clone with a cr4.

I have no back ground on this console & no original dumps because the guy he bought it from didn't give him anything & everytime i read it in jrunner it says header is wrong, how should I proceed?

I soldered a nandx pinheader in to read the nand so I know the soldering is good on that.

Also suggest him that I put a phat demon in it so I don't overwrite the only working nand that I have?

 

[Krafter]

You'll have to create a retail image. Have a look at the JR manual. The error is because the image on the NAND is a glitch image.

 

[morinzo]

how do I get the extracted files needed? I opened the dumped nand and entered the cpu key i get in xell and it says bad cpu key?

the console boots perfectly fine to fsd.

I will post the jrunner log soon as it's finished reading again..

 

[morinzo]

===================================================Wednesday, December 10, 2014 1:22:51 AM


J-Runner v0.3 Beta (6) Started






Checking Files
Finished Checking Files
Downloaded *xeBuild/12611/_jtag.ini
Finished Checking Files
Downloaded *xeBuild/12625/_jtag.ini
Finished Checking Files
Downloaded *xeBuild/9199/_jtag.ini
Finished Checking Files
Version: 10
Flash Config: 0x00AA3020
Error: 250 reading block 0
Error: 210 reading block 1
Error: 210 reading block 2
Error: 210 reading block 3
00AA3020
Jasper 512MB
Jasper 512MB Manually Selected
Reading Nand to C:\Users\Morinzo\Downloads\J-Runner\output\nanddump1.bin
Reading Nand
Error: 250 reading block 0
Error: 210 reading block 1
Error: 210 reading block 2
Error: 210 reading block 3
Error: 210 reading block 4
Error: 210 reading block 5
Error: 210 reading block 6
Error: 210 reading block 7
Done!
in 13:29 min:sec


Reading Nand to C:\Users\Morinzo\Downloads\J-Runner\output\nanddump2.bin
Initializing nanddump1.bin..
Header is wrong..
Reading Nand
Error: 250 reading block 0
Error: 210 reading block 1
Error: 210 reading block 2
Error: 210 reading block 3
Error: 210 reading block 4
Error: 210 reading block 5
Error: 210 reading block 6
Error: 210 reading block 7
Done!
in 13:17 min:sec


Comparing...Takes a while on big nands
Bad Block ID  0000 Found @ 0x01FF [Offset: 0x41DF000]
Block ID 01FF [Offset: 0x41DF000] remapped to Block ID 0000 [Offset: 0x0]
Bad Blocks Remapped
Bad Block ID  0000 Found @ 0x01FF [Offset: 0x41DF000]
Block ID 01FF [Offset: 0x41DF000] remapped to Block ID 0000 [Offset: 0x0]
Bad Blocks Remapped
Nands are the same

 

[Slayertex6]

Boot Xell and see if it shows both of the keys. Take those and build a new nand from donor files.