Hi there,
I am wondering if anybody experience or can help me out with this problem. I have a version 1.6 XBOX installed with Xecuter 3 install about a month and a half ago. It was working fine until, one day I boot the XBOX and all it did was fragging. The first thing i did was try to disable the modchip and give it a try, this sequence of events happens. Red on the panel and eject blinks a few times and panel turns blue, try to boot a 3 times and shut itself off.
Then I removed the xecuter 3 chip and give it a try. I now get blinking green and no video/audio and I can't even eject the dvd rom to do a eeprom fix. I checked all LPC connection and all rebuilt wires and yes they are rock solidly soldered in. Since it did work for a month and a half, and I resolder the pin-headers and LPC rebuilt, it's confirmed it's nothing to do w/ bad soldering.
I don't know if the 680Ohm and cut off LFRAME0 fix will have saved the board from this incident. I have not been implementing that fix on all 1.6 installs I am doing. Would it be necessary to implement that fix in? There are like people saying "you need it" and other people saying it's "BS". So I am confused on this one.
I would appreciate any kinds of inputs about this problem.
Thanks in advance.
I am wondering if anybody experience or can help me out with this problem. I have a version 1.6 XBOX installed with Xecuter 3 install about a month and a half ago. It was working fine until, one day I boot the XBOX and all it did was fragging. The first thing i did was try to disable the modchip and give it a try, this sequence of events happens. Red on the panel and eject blinks a few times and panel turns blue, try to boot a 3 times and shut itself off.
Then I removed the xecuter 3 chip and give it a try. I now get blinking green and no video/audio and I can't even eject the dvd rom to do a eeprom fix. I checked all LPC connection and all rebuilt wires and yes they are rock solidly soldered in. Since it did work for a month and a half, and I resolder the pin-headers and LPC rebuilt, it's confirmed it's nothing to do w/ bad soldering.
I don't know if the 680Ohm and cut off LFRAME0 fix will have saved the board from this incident. I have not been implementing that fix on all 1.6 installs I am doing. Would it be necessary to implement that fix in? There are like people saying "you need it" and other people saying it's "BS". So I am confused on this one.
I would appreciate any kinds of inputs about this problem.
Thanks in advance.
