LITEON DG-16D4S - SLIM Help, don't know what to get.

[betaalpha]

Its been a while since i've flashed firmware to xbox 360s. I just recently got a xbox 360 slim and was wondering what I need, I got confused at what was required to flash a slim drive. What i do have is my old ck3 pro and probe dont know if that will help. thanks.

Its a Liteon 0225 i think.

 

[WestCoastConsoles]

You need to figure your chipset properties out first look at the chip in the drive and see if its 03 or 05 on the last line of the chip on the pcb. an x360usb pro and what ever else is needed depending on chipset. sputnik probe or switch for the mxic and unlocked pcb/pro kit/ or kamikaze hack for the winbond

 

[betaalpha]

so an x360usbpro is need for both correct?

 

[Teajunkie]

X360 usb and a power source like the ck3i or ck3 mini.

First you need to open the drive and check the Chip inside.
If you have an 03 then you can use a sputnik probe or switch
If you have an 05 then it's either kamikaze or replacement tx pcb.

 

[whoseanthony]

Winbond = TX PCB
MXIC = Sputnik or TX PCB

All depends if you are handy enough to solder. Otherwise the TX PCB is a no solder solution that will work with both.

Add a X360USB Pro and CK3i and you are good to go

 

[betaalpha]

So will my old ck3pro work or do i also need to grab a ck3i?

 

[ball00]

CK3 pro is fine. You only need it to power the drive.