JTAG Help getting falcon r-jtag to boot

[Ressko]

Dips 7 and 2 with no vault jumpers. Can only boot into Xell. whan dash boot is attempted it gives 3rrod 0010
Dips 7 and 2 with 1.2 vault jumpers gives rrod when i try to boot into both dash and xell
Dips 7 and 2 with 1.8 vault jumpers Gives same results as with no jumpers.

I dont know what i can try from here can anyone please giver me some info.

 

[chronic1553]

can you take some clearer pictures of your work like of the wiring, and post qsb

 

[Martin C]

Thanks for the reply Martin. Everything seems to be working now. I just cant find the right settings to get it to boot. I curently have the freeboot image writen to the console. I have resoldered everything and touched up the post points. Do you have any suggestions on what settings i could try? im not a complete noob, ive done over 20 consoles and the only issues ive ever really had have been with RGH2 phats and this one. Please respond with some suggestions on what I could try.

Thanks

Without seeing your POST output, no.

noobs don't use RATER.

 

[Ressko]

can you take some clearer pictures of your work like of the wiring, and post qsb

I have just inspected my post out and all of the connections are fine besides the first one on the very left. I think i may have positioned the qsb to far on top of the point, is there any way i could remedy this? Maybe by using a different point?

 

[chronic1553]

your best bet would be to remove it, and put it back on. but you need to be extremely careful not to damage those pads. use desolder braid, ideally you'd want to use low melt solder.

 

[Ressko]

your best bet would be to remove it, and put it back on. but you need to be extremely careful not to damage those pads. use desolder braid, ideally you'd want to use low melt solder.

Like from what i can see the solder has flowed but im not 100%

 

[Ressko]

Ok just forget this thread. i threw out my post out qsb because i rippd pads. im gonna buy another. thanks for the support lads

 

[chronic1553]

did you rip the pads off of the motherboard or the post qsb?