hi , need help with my falcon jtag im using nandx and alternate smc points i got E79 then 3 red rings tried flashing original nand back an nothing still have 3 red ringsive checked my sildering every thing looks find i used the kit that comes with the nandx how can i put original nand back so it can boot back to normal
help got 3 red rings using nandx after writing xellus
- Thread starter imparable08
- Start date
BL4K3Y
VIP Member
What's your secondary error code? It seems to me that your console has infact developed the dreaded Red Rings of Death.
secondary error 0022 and 3 red lights every thing was working after i flashed xellus it whent to E79 then 3 red lights
BL4K3Y
VIP Member
but every thing was working OK has original x clamps never had red rings before so you recommend me to re-flow it
BL4K3Y
VIP Member
what makes you think that is only a regular red ring of death and not something else that is related with xellus
Doesn't mean anything... By changing the forces on the board (example: tightness of the bolts) it can generate a RROD...
BL4K3Y
VIP Member
You said in your first post that you restored the original NAND and it still had the error. If it was a JTag issue, it wouldn't have the problem with a stock NAND.
jtag360.nl
VIP Member
BGAMods
VIP Member
You beat me to it. 0022 happens usually when two points bridge or loss of contact most people will get 0022 after a poor reflow ie to high of heat. Jtagging can add stress to the unit resulting to red ring if done improperly. If your console is close to rrod moving it around can push it that extra inch. Try the reflow because you can pull the points apart. As flash said he's done it a bunch of times
Last edited:
BGAMods
VIP Member
1. reflow
2. reball existing GPU
3. replace GPU.
that should always be the order in which you work.
2. reball existing GPU
3. replace GPU.
that should always be the order in which you work.
jtag360.nl
VIP Member
Realy, I try to reflow it a few with the 0022 but i didn't work.
And I realy know how to reflow.
After reballing them, they start up perfectly.
And I realy know how to reflow.
After reballing them, they start up perfectly.
Last edited:
Some times a reflow does not work depends what fault it is and depends how you reflow it and too much heat then you deffo need reball or new chip if you've toasted it depends really
BGAMods
VIP Member
0022 can also be a dead GPU or cracked solder joint. it can also be a shorted or damaged cap. its a dodgy error but i always start with a reflow.
he should also check theres no trace damage on the board.
he should also check theres no trace damage on the board.
2 days ago i´ve write xell and have the same problem, i´ve write the original nand back and all was fine. but i write only the 16mb from 512mb nand back.
BL4K3Y
VIP Member