well, this is my first mod ever, and when I soldered the first time I could'nt get my 3.3 volt led to light. so I tried to desolder the pcb board from the motherboard and ruined the solder point where it solders to the d0 on the motherboard. I took all of the silver shiny part off of it. now when I hooked my chip back up all the lights on the chip work, but it just boots to the m$ dash and the led on the external switch stays red. the faq said that this is a d0 problem so I moved the grey wire straight to the motherboard and soldered it on the d0 point there. still just the red led on the external switch. I have desoldered and resoldered the d0 to the motherboard at least 20 times in the last hour and still can't get the switch to light blue. can this be caused by anything else ? or is this only caused by the d0 not being hooked up right. everything else works fine and I can still boot to m$ dash, but I want to get this chip working and swap out my hardrives and back up my games. thanks in advance for any help 
