accidental jtag update
Got xbr up and running and put in hdd in from my other console it asked me to update(ok here is the kicker) when I had done my soldering I used the alternate r6t3 point on the bottom of board(u6t1) and bridged those points together.Now I'am a trial and error person I learn from mistakes so when I installed my harddrive it asked me to update(I wanted to put the accidental update to the test being I soldered the points together to prevent an accidental update) so I did and it gave gave me an error stating something like the update was unable finish or install. At this point system was still running fine. I turn off for a few hours and then go back to it and when I power up I get an Exx error I believe it was e71 with a 1013(update error). At this point I was cussing my self out for taking this update. Question is what is the u6t1(r6t3) removal or bridge for if an update is applied and takes and if it did not update what do I have to do to fix THIS DUMB MISTAKE? I already tried to erase nand and re-write xbr and get same error. Any ideas or suggestions will help good or bad.
