no drive is not half way. I used the ck3 probe 3 to obtain the drive key, i have the key saved. ck3 pro wont elect drive to get it to half way (bc its in vendor mode, i think) if thats what i need. so i have to find a way to half-way the drive?
LITEON 83850 v1 HELP JF Not detecting drive.
- Thread starter kharlisson
- Start date
you can manually open the tray i believe, i used to use a small screwdriver and slide it under the draw. when u get t a little it will come right out, but remember to pull fully open then close half way.
ok i manually got tray half WAY open. in the firmware tool tab, i have the dummy.bin file loaded, have the 1.91 loaded in the target with the key spoofed. drive is in vendor mode but when i hit write says "Drive returned Invalid Status". log says Getting Status from port 0xE880
Invalid Status 0x80
Invalid Status 0x80
so what do i do to fix it? what do you mean "i think you IC got error"
Last edited:
Teajunkie
VIP Member
It's already here ME :rolleyes2:cant wait for a TX robot that can take the xbox apart and then flash the drive and put it back together (Be made by TX in 2020)
---------- Post added at 18:52 ---------- Previous post was at 18:50 ----------
When you see this .......
DONT power cycle just click write!
i tried that and got.
Sending Lite-On-Erase request to port 0xE880
..............
Drive returned Status 0x80
.........
Serial flash found with Status 0x72
Manufacturer ID: 0xC2
Device ID: 0x11
Flash Name: MXIC(MX25L2005)
Flash Size: 262144 bytes
Getting Status from port 0xE880
Invalid Status 0x80
Getting Status from port 0xE880
Invalid Status 0x80
Last edited:
Try pressing intro and power cycling at this point and if that doesn't work try liteon erase again
lol i ended up taking it back to game store and got another used back. was a Liteon 7 series and had no problem at all. read to key fine, flashed fine. thanx for all the help