LITEON DG-16D4S - SLIM help liteon 0225 brick

[sp4rkst4rt3r]

i was trying to flash a drive 0225 with winbow chip. i read the key, without no problem.

Have you got the JF log showing how you read the key?

---------- Post added at 18:03 ---------- Previous post was at 18:01 ----------

When you shut down JungleFlasher it asks you to save a 'JF' file.....

Post the file that has the read/dump information (i.e. the first one you did)

 

[roger_tik]

Have you got the JF log showing how you read the key?

---------- Post added at 18:03 ---------- Previous post was at 18:01 ----------

When you shut down JungleFlasher it asks you to save a 'JF' file.....

Post the file that has the read/dump information (i.e. the first one you did)

i don´t have that file. like i said my pc freese and didn´t responde, i guess that´s why the drive become this way.

 

[BraveH43]

have you used your USB Pro successfully in that USB port before?
its not a USB 3 port is it?

 

[roger_tik]

have you used your USB Pro successfully in that USB port before?
its not a USB 3 port is it?

i have been using always the same usb port. i have flashed fat liteon, benq, 9504 and 0225 with the sputnik unlock always with success.

this was my first time with the kamikase unlock, and everything look fine until the pc freese.

 

[BGAMods]

on the phat liteons if it gave bad flash properties then another intro whilst in vendor would sort it. if i was you id try that, worst case scenario is buy another pcb as you already have the key.

 

[roger_tik]

on the phat liteons if it gave bad flash properties then another intro whilst in vendor would sort it. if i was you id try that, worst case scenario is buy another pcb as you already have the key.

i guess the problem is on the vender mode. it look likes is not entering vendor mode properly.
when i do into, i received a message of retourn MRA to original position, but i am not using any MRA method.