well i did my jasper BB today got it flashed with the glitch dash board now when i play a game it locks up on me i have reflashed the nand file with a donor under 360_Multi_Builder_v0.7 and its still locking up i checked all my wiring resoldierd the i just dont know where togo from here now please ill post pictures tonight when i get home:facepalm:
ANSWERED help on coolrunner on jasper BB 512
- Thread starter nivenspyder
- Start date
Martin C
VIP Member
It's going to be wire routing an interference. Wire it according to the pictures in the install guides.
I had pretty much the same issue on a 16mb jasper. I routed the green wire under the x-clamp and it kept freezing.
By routing it exactly the same as the install pictures, it now works an absolute charm. Check it's the same as in uber's picture
By routing it exactly the same as the install pictures, it now works an absolute charm. Check it's the same as in uber's picture
Martin C
VIP Member
Run the green wire closer to the x-clamps and try again.
Do you notice any 'stuttering' when the console boots?
Do you notice any 'stuttering' when the console boots?
Martin C
VIP Member
its booting up good now played batman for about 5mins and its working thanks so much Martin C big help man now i know what to do i was about to chuck this thing out the window lol
Try threading your green wire and blue wire through seperate holes near the southbridge chip.
Also, are you using the recommended capacitor?
Also, are you using the recommended capacitor?
x360ccm
BANNED
BL4K3Y
VIP Member
The Rev B has a two solder pads you can bridge, the word "CAP" is printed on the PCB near these points - I believe it is a 100nF cap.
Last edited:
this one came with it.....its not a ver b at all it with the blue cap that i have to soldier to grd to a points
BL4K3Y
VIP Member
well i got it glitching under 4 sec.. and played it for 1hr been working great thanks for all the help yall have given me 