Help please?

[Lewis96]

hey guy's i was wondering if someone could help me for the past few nights i have been trying to get my nand-x to read the nand of my 7371 falcon as far as i can see everything is soldered correctly i am using the wires of the pin header way thing.
but my problem is that when i plug in the power brick the light on the power brick goes red instantly...
so i was wondering if someone could help me please? <3


Edit: Yes, i know what has happened thanks to the great site here but my xbox has shorted:/
now i just need to figure out to replace the offstets. <3

Thanks TX! <3

 

[manwithoutname]

Generally a fault with the mosfets will cause a 360 not have power but not in my experience cause the power brick to go red every time it's connected to the console.

As you explained that you have shorted the console during the NAND-X installation, it is most likely that the installation is still causing the short!!! If that's the case you'll need to resolve that.

 

[Lewis96]

Generally a fault with the mosfets will cause a 360 not have power but not in my experience cause the power brick to go red every time it's connected to the console.

As you explained that you have shorted the console during the NAND-X installation, it is most likely that the installation is still causing the short!!! If that's the case you'll need to resolve that.

ya, it's not that i de-soldered everything and its still shorted. :/

 

[marshamods]

maybe you dropped a piece of soder on the mobo somewhere else. Give a scan over the motherboard and look for possible shorts. Post some high res pics and I can help you out.