Help Someone!!!!!!!!!!!!!!!

[wself]

Ok I have been try to get my friends xbox up and running. Ok the problem is when i boot up the xbox is get to the rox my box screen and just sits there with the light around the eject just flashs orange.

Also I have the xecuter 3 chip in a Ver 1.0 box I flashed the chip with X 3 bios 3294

Any help would be great

 

[DJBOOBY]

he did not set password in x3 bios config

 

[wself]

how do i do that, or what do i need to do to get it working

 

[DJBOOBY]

was it working at all before this happened

 

[wself]

it was working before i modded it, this is a far as i have gotten in the install

 

[DJBOOBY]

is the hard drive plugin check its pluged in back of h/d as well as motherboard

 

[wself]

yes it is pluged in on both ends, the flash went great i thought. any other ideas

 

[DJBOOBY]

try holding down white button on controller on bootup of xbox to get x3 bios config dash set to boot m/s dash if you do not get config try reflashing chip did you have switch set right on on off off off or off on off off off when flashing it

 

[wself]

Tried the white button but it don't do anything, as for when i flashed it the switchs were set to
on on off off off.

Also have been reading through here about the password being able to do this, I was never ask to enter a password or anything

 

[DJBOOBY]

where did you get bios x3 3294 if not #xbins get it from there and reflash the chip with it

 

[wself]

that was where i got the bios from was xbins, to reflash it what do i need to do

 

[DJBOOBY]

get flashbios screen backup power eject at same time on boot up
or set switch setting to off on off off off then when flashbios screen cames up change switch back to on on off off off then reflash the chip with x3 bios

 

[wself]

ok cool will try in a few thanks for the help