HELP! Stuck with sputnik 360 switch

[ironicmullet]

So I was able to slimkey my 0272 to get my dvd key. Im using ck3i and x360usb pro. I then click intro / device id. That went well, put my drive into vendor mode. I then click the spi status to unlock the drive. I put my switch to unlock at 10 ohms, then the breaker that controls my computer flipped causing my computer to shut down in the spi process. Now JF doesnt recognize my drive. I tried re clicking intro / device ID again but no luck? Is my drive bricked now? I hooked it back up to my xbox and I can open and close the tray but even with a game in the drive i get open tray...any suggestions?
I took the sputnik switch off and fixed the trace and still no luck.

 

[ReMix]

try putting the drive in vendor mode
i know you can't see it

power cycle everything, make sure your ck3 is still functional, your x360usb still works (try another drive for detection purposes if you have one)

then send intro/device id to 0x000, press yes, then power cycle the drive
hopefully your drive will go into vendor mode

 

[ironicmullet]

Alright man ill give it a shot

 

[ironicmullet]

well i tried my 0225 and everything is fine as far as my ck3 and 360usb pro goes. Ive been trying to get the damn thing into vendor mode for 3 hours now. You think its bricked??

 

[ReMix]

well, bricked isn't a good word for it :/

most likely, a single component is toast
it may be time to replace the pcb

(i would be willing to take a look at/buy your broken one though! PM if interested)