Hey all.
Can someone offer some suggestions on how to trouble shoot my install? I am FRAGing.
I used the PCB board. I have a 1.6b. I removed the 5v pin from the header pin, and I ran a wire to the power source. This was a requirement for 1.6, but I don't know if it is for 1.6b. Anyway, the LEDs on the chip switch do work, so I assume it has power.
I used a multimeter to test for a solid circuit between each of my solder points and their intended destinations. All of my joints seem to have congruity.
Any suggestions would be appreciated.
Can someone offer some suggestions on how to trouble shoot my install? I am FRAGing.
I used the PCB board. I have a 1.6b. I removed the 5v pin from the header pin, and I ran a wire to the power source. This was a requirement for 1.6, but I don't know if it is for 1.6b. Anyway, the LEDs on the chip switch do work, so I assume it has power.
I used a multimeter to test for a solid circuit between each of my solder points and their intended destinations. All of my joints seem to have congruity.
Any suggestions would be appreciated.