Help With 1.2 Fragging after chip

G

gazzadvd

Noob Account
Feb 4, 2006
2
0
Could anyone help please.

I have what I think is an xbox 1.2

I purchased a xecuter V.26 CE, installed the wired pin set, turn on xbox, no video output and it frags.

Boot xbox with chip turned off and it boots straight up, I have also tried with bank 2 switched over and i get the same.

I have followed many problem solving threads before posting, all the voltages are there and correct, the DO seems fine, checked the continuity with another point, I do have the programmer and have installed bios 5035, which says its fine when I verify.

Could anyone point me in any other directions,
 
G

gazzadvd

Noob Account
Feb 4, 2006
2
0
Yeah I used the old bios version,

I have also had the meter out and checked all the voltages on the wired pin header, they all match what they should be, I followed all the traces back and tested they all seem fine, there was 1 where I could'nt see a trace, but the voltage was correct.

I have followed that many problem solving threads trying to solve it, but unfortunately I am at a loss now.
 
F

Fantmx

VIP Member
Feb 15, 2004
2,274
0
Check your switches with the multimeter. Check the last link in my sig for switch info.
 
You must log in or register to reply here.