Help with Bios

[stlmac]

This is my first Mod attempt I have a 2.6 with the solderless adapter it's on 1 1.3 board when I boot it up it loads up Flashbios 3.0.1.

I networked and flashed it and it went thru and then the xbox shut off (So I assumed it went fine). When I turn it on, it goes right back to the same screen.

PLEASE HELP ME!!!!!!

 

[Poida^]

What did you flash it with?

 

[stlmac]

Thanks for trying to help. I used Bios 3.0.3 at team executer, I wonder if I need to flash with 4983.BIOS but can't find it, like I said this is my first attempt.

 

[DJBOOBY]

you need to flash it with x2 5035 bios
you can find it at #xbins
http://www.xbox-scene.com/articles/xbins.php

 

[AngelosDracul]

Recently I tried Xbins... they seem to have only the older bios... no 5035, I looked under all the folders... no avail. Maybe, like I said, maybe I wa slooking in the wrong places, but I found it on the xbox-hq. *shrug* Still having problems, though... network flashed and no video when I boot off bank one..

 

[DJBOOBY]

do you get flashbios still

 

[AngelosDracul]

I didn't have any problems until after I got the 5032 running... The damned thing. I was running it with my case open, just in case something came loose... Nah, I was just lazy. Finally got a working BIOS, flashed bank one, removed my softmod, booted AID 2.11, setup my hacked dash, everything went great. Even ran a few of my old apps, nothing out of the ordinary.

So, bank 1 was 5032 (I intended to try EvoxM8+ later) and bank 2 was still the flash 3.0.3. Sonofabich, if when I didn't close the box, the damned thing started fraggin on me again! Still boots with the chip off, no problem, but somehow bank 1 gives me no audio/video anymore, and bank two powers up, shuts down, powers up, shuts down, powers up, fraggs flashing green/red no vid. I'm pissed! What did I do wrong?

I'm ordering a programmer now, just in case this happens again (i'm the only one I know with an xecuter in my area, so I can't do a hotswap.

 

[DJBOOBY]

dont think its bios check your install may have move chip when put top on solder the chip in

 

[AngelosDracul]

Chip is in, soldered in using the great guides from here. Used the wire install just because it was simpler and looks cooler having the chip mounted on the sheilding .

Anywho, I'll definitely go over the solders again, but I just think it's a damned BIOS issue. Like I said, bank one acts like there's no Bios at all (boots, but no video, no audio, nothing). Bank two (originally my flash bios bank) was booting, shut down, booting, shutdown, booting, frag (green and red blink)