please forgive me if this is a stupid question, i am a noob
after fitting x3 into a1.6b,every thing turns on ok,all the lights are on the pro switch panel ,blue x,protect button red ,on/off switches light up when on,and green eject button,so far so good,what should i see on screen at this point,all i have is a blank screen. the only thing i can access is blue bios screen 3.01 on
banks 3 (256) and bank 34 (512) nothing else,i have been told by vendor
that the chip has 3.03 but i cant find it anywere,ive tried the power+eject
to boot from back up but still see nothing,is this a solder or bios problem
and should i see a blue bios load screen on all banks
after fitting x3 into a1.6b,every thing turns on ok,all the lights are on the pro switch panel ,blue x,protect button red ,on/off switches light up when on,and green eject button,so far so good,what should i see on screen at this point,all i have is a blank screen. the only thing i can access is blue bios screen 3.01 on
banks 3 (256) and bank 34 (512) nothing else,i have been told by vendor
that the chip has 3.03 but i cant find it anywere,ive tried the power+eject
to boot from back up but still see nothing,is this a solder or bios problem
and should i see a blue bios load screen on all banks
