Help with connecting 360 to pc!

[surivdragon]

Hi i have put my 360 into mode b, i know this because the drive ejects after i have closed the tray, and the green light flashes on and off all the time.
I have a sata cable and sata port on my motherboard in my pc but it doesnt show up under my computer.

Can anyone help?

McGee

 

[RSX_Integra]

u have to be using a via chipset sata are u using one of these?

 

[abeerdrinker]

Doesnt have to use a VIA card but it all depends on what 360 he has. You dont need the VIA to flash Hitachi's but you will need it for some sammies.

What 360 do you have? also do you have the sata ports enabled in bios? Make sure it plugged into Sata 1 port

 

[surivdragon]

i have the 59dj. the light flashes on and off, but the two press thing to open it doesnt work. is that a sign the 360 is bricked?
But the drive goes in on its own when i eject it and also it shows up in the bios set up but not in windows.

Help

 

[abeerdrinker]

Verify the orig.bin and hacked.bin have the same key. See if you can even not that you want to be able to flash the drive from a dos prompt. Did you use Slax or resistor method when u first started. when did it fail or where did it fail at? Dumping the orig.bin or flashing the hacked.bin.

Did u use FW toolbox ? what version

 

[surivdragon]

i used the 1k resistor way. it started to flash the on and off light and it still does, but the drive doesnt open with two pushes it opens with one and then it closes itself.

Then i connected the drive to my computers sata input, and it recognises it in bios but not in windows.

 

[surivdragon]

Help!