help with E10 error

nolimit5005

Full Member
Nov 25, 2010
49
0
hi

i sent a post yesterday but i think the mod has removed it

well my problem is that after flashing the xbox through the xell the system has shutdown automatic and when i started it i got only the solid green led and black screen i can't run xell and when i flashed back to original i got 3 red rings (E10) 6sec from starting the console now i can't back to original nand or to xell

also when flashing xell i got only the solid green led in the middle
 

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
Sounds like damage to the CPU_RST/CPU_BYPASS. Post some closeup pics of the underside of the board.

Martin C said:
5s- issue with CPU_RST/CPU_PLL_BYPASS
15s - LDV
30s - GPU issue.
 

nolimit5005

Full Member
Nov 25, 2010
49
0
well i will try to add pics but i desolder it any solderd it again and nothing also it worked fine in the first time

also when i tried to flash the hacked image directlyto the xbox no rrod only black screen and solid green led could be the coolrunner is dead?
 

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
Do quote me as I may be wrong but I believe that the ecc image can hide this error if it's related to damage done to the CPU_RST/CPU_PLL_BYPASS. That might have been why you only got a black screen.
 
V

Vest1ge

well i will try to add pics but i desolder it any solderd it again and nothing also it worked fine in the first time

also when i tried to flash the hacked image directlyto the xbox no rrod only black screen and solid green led could be the coolrunner is dead?
Have you tried booting into XELL at this stage with the eject button, as if there is an KeyVault error or even some bad blocks the console won't boot dash, but can boot into Xell.

Do quote me as I may be wrong but I believe that the ecc image can hide this error if it's related to damage done to the CPU_RST/CPU_PLL_BYPASS. That might have been why you only got a black screen.
Really need to see some pics of the soldering to see if its software or hardware...
 

Justice1231

VIP Member
May 4, 2011
1,005
0
Adelaide, Australia (down south)
Do quote me as I may be wrong but I believe that the ecc image can hide this error if it's related to damage done to the CPU_RST/CPU_PLL_BYPASS. That might have been why you only got a black screen.
Id have to agree with this, as i was given a rrod board and without thinking i installed the coolrunner to try and get the key etc. I had the solid green light and black screen, needless to say when i put the nand back to stock i was stuck with the 3 red lights
 

nolimit5005

Full Member
Nov 25, 2010
49
0
no xell too after i flashed through the dame usb stick i got nothing only rrod(E10) when flash to original and black screen + solid green led when flash to hacked image or flash the ecc image

i hope the cpu or gpu is not f*cked up

plus i put a multimeter in the original points and in the alternate points to check the continuity i find all good so i don't think it's bad solder
 

nolimit5005

Full Member
Nov 25, 2010
49
0
now i removed all cool runner wire's and flashed to original nand and still have the same problem RROD(E10) after about 5 or 6 sec from start the console

another question can bad flash give the E10 error?