RGH help with j-runner can not read hand

[nightcaller]

hi all im trying to read the hand of my jasper dash 16547 with jrunner its the old xbox 360 not the slim ive checked my soldering and redone it but still the same error ive used the jrunner to do a slim yesterday and it was all fine error below


28 January 2014 15:25:18

J-Runner v0.3 Beta (4) Started


Version: 10

Checking Files
Flash Config: 0x00000000
Can not Continue
Finished Checking Files
Version: 10
Flash Config: 0x00000000
Can not Continue

 

[nofeloniesyet]

hi all im trying to read the hand of my jasper dash 16547 with jrunner its the old xbox 360 not the slim ive checked my soldering and redone it but still the same error ive used the jrunner to do a slim yesterday and it was all fine error below


28 January 2014 15:25:18

J-Runner v0.3 Beta (4) Started


Version: 10

Checking Files
Flash Config: 0x00000000
Can not Continue
Finished Checking Files
Version: 10
Flash Config: 0x00000000
Can not Continue

View attachment 24544View attachment 24545View attachment 24546View attachment 24547

nand wires look to be cold soldered.

 

[nightcaller]

i don't understand sorry ive redone them 2 times now with flux all look to be in place well to me i will re do the again but i do not think it will help

 

[nightcaller]

well i have redone the soldering yet again and its still doing the same thing so i dont think its my soldering skills at fault

 

[Martin C]

You've soldered them to the wrong header.

Look at the diagrams in J-Runner AGAIN.

 

[nightcaller]

thanks for that mate ill tri again just wired it to my slim to check it was ok and its fine

 

[gavin_darkglide]

If it doesnt work when you solder them to the correct points(you soldered them to the jtag header, so instead of talking with the southbridge, it is trying to talk to the gpu. hopefully you didnt break anthing in the process), then I would be looking into this. http://team-xecuter.com/forums/showthread.php?t=77908