Help with my rgh

R

Ramsay2011

Junior Member
Mar 7, 2011
15
0
Hi
I was doing an rgh last night when i hit a little problem
I carefully soldered all wires into place and put the coolrunner into place
I am using a nand pro and j runner to donall the nessesary flashing
I started by reading the nand which went throu great twice
Then i programmed the coolrunner went fine
I then created .ecc that went fine
Then wrote .ecc that went fine
Now i then (pretty sure) i unplugged 360 for 10 secs disconnected from nand x and coolrunner
And im sure i switched the 360 on with the eject button with the coolrunner still set to prog
After it didnt boot i realised what i had done so powered down and switched to norm
Now when i power on (have rol plugged in amd fans)
I get one green light flashing in the centre but no xell boot screen im gettin no output at all
I then tried to read the nand as before and im getting nothing it seems to read and verify the nands as normal but there are no values in j runner and i cant get any output

Ive now disconnected the coolrunner wires and going to re solder them just in case

Any help would be greatly appreciated and if pics are needed i will try getting them when i get home

I have done an rgh before using jtag tool and it went withou a hitch

Thanks in advance
 
R

Ramsay2011

Junior Member
Mar 7, 2011
15
0
Ok thanks i will get pics of solder when im home
I waited a good bit for glitch actually got 2 red lights when i waited
The coolrunner has a red light on and flashes green every 5-10 secs when the 360 is running
Its a zephyr mobo
 
R

Ramsay2011

Junior Member
Mar 7, 2011
15
0
I will try lol i really inly have my iphone 4s so hopefully if not i will try and find a ood camera
Thanks for the help so far
I tried to re flash the coolrunner but on j runner i get error 0x003 i think and it fails
It did however flash the first time :)
 
G

gamehawk55

VIP Member
Mar 21, 2006
202
33
Canada
www.chaotic-consoles.com
Ramsay2011 said:
Ok thanks i will get pics of solder when im home
I waited a good bit for glitch actually got 2 red lights when i waited
The coolrunner has a red light on and flashes green every 5-10 secs when the 360 is running
Its a zephyr mobo
Click to expand...
If your getting 2 red lights on the front ROL then that usually means that you are overheating something. Either that or you now have a cold solder joint under the CPU or GPU causing it to think its overheating. Zephyrs are HORRIBLE for broken solder joints. The last one I did went RROD on me because the removal of the small black T8 screws under the x-clamps on the case caused too much pressure to be released from the GPU and caused a broken joint. Luckily after screwing everything back in tight and overheating the GPU it worked again and still does today:p. I'm not recommending you overheat it but in rare cases it does work lol.
 
You must log in or register to reply here.