hey every one lil help pls

mrbiggzz79

Full Member
Aug 12, 2009
49
0
Nassau,Bahamas
ok heres what i have a liteon 93450c i jus flashed it back in december LT+ game were woking fine. but ever now and again the system would freeze. quick reset and am good to go. but the other day inotice that i had what i think is the open tray problem it keeps sayin opening and when u open it doesnt wanna close any ideas thanks in advance
 

mrbiggzz79

Full Member
Aug 12, 2009
49
0
Nassau,Bahamas
laser is going dead. Replace the laser and or whole drive.
sup question i changed the ribbon and the laser same results. am jus tryin these things tell the replacement drive reach. do u think if i remove the lt clip and repair the trace cuts it will work. if the traces are the prob at all??? thanks in advance
 

mrbiggzz79

Full Member
Aug 12, 2009
49
0
Nassau,Bahamas
hey fam lil help pls. here the skinny as mention above . i got a new liteon drive but is a 7 series should i
1. swap the pcb boards
2.flash my 9 series in the 7 if so how is that done
3. take off the lt switch and repair the trace cuts.
i would really like as much feed back as u guys can give pls .
or u can help if u see this MR
marshamods
 

marshamods

VIP Member
Mar 7, 2010
1,905
0
ohio
I would do 2 because it is the easiest for a novice solder, load up orig.bin and load up 93450V LT+, liteon erase, write, outro.
 
  • Like
Reactions: mrbiggzz79