Hitachi 47/ Error 64 but it still works

Jedit Ojanen

Noob Account
Feb 11, 2003
3
0
This is not the first time I modded a system, but the first I have moded a 360. I have the hitachi 47 and I went through the video/tutorial which was excellent by the way. So everything was fine I checked it played Oblivion and a burned movie (which I have the original of :D ). So I brought it home played for a few hours. The next day I turn it on and I get error 64 and all the lights that go with it. So I restart a few times...power down and check cables etc. and nothing. So I read about it a little and I decided to try a few things. While the 360 was starting up I ejected the Dvd multiple times to get it to recognize the dvd drive (which is what the error 64 is). So I after I do that it recognizes my controller and the dashboard comes up. I've been using it for a week and I keep getting error 64 unless I eject the DVD drive multiple times. I haven't found anything else quite like this so I was wondering if you could help. Did I have a semi-bad flash? Should I try to recover? Or should I say i'm glad it still works and if that's all I have to do then I should deal with it? Thanks for your help...none of this could've been done without your site. Thanks so much!
 

zerach

Console Master
Dec 8, 2002
1,351
0
i would go back orig firmware.make sure it does good if it does then i would try reflashing again.that is weird what its doing.
there again that is just what i would do.
 

Jedit Ojanen

Noob Account
Feb 11, 2003
3
0
I appreciate the quick response. I just double checking as far as doing this procedure. I need to hook up the hard drvie again and use the restore x. And then reflash it using maximus-gariopa v2.2 or is there a more update version? Thanks again!