HITACHI 79 Hitachi 79 detected but wont show up in vendor or go mode b

unclehowie420

Noob Account
Sep 26, 2012
3
0
sorry to post I looked through pages and pages and even googled this and I can't figure out whats wrong.
Im using the usb pro v2. Like it says in the title it shows up on my computer on the drive drop box on the bottom when i try mode b and when i scan for it but it wont show in the port properties/vendor section. I've tried it on two different computers on vista 32 and one win 7 64. I have heard it might work on windows xp but don't have a comp to try it on. I have also tried slax on both computers and it wont go mode b, any help would be greatly appreciated. Thank you
 

unclehowie420

Noob Account
Sep 26, 2012
3
0
yup have it already to go just tells me it failed prob cause its not in mode b, everything in that section wont seem to work prob cause it wont show up in port properties. i actually just finished fully downgrading to xp 32 bit and still nothing. ive been at this thing all week its driving me crazy!!!

---------- Post added at 19:06 ---------- Previous post was at 19:00 ----------

also, what i wrote was a little confusing it will show up on my computer, and it will also show in jf under drive with the drop box. when i scan it says hitachi found but it wont show in "port properties/vendor" section above the mode b and 79 unlock. i dont know if im just doing mode b wrong.
 

FlashDrive360

VIP Member
May 17, 2011
439
0
What chipset are you using as never had a problem with the x360 USB pro


Sent from my iPhone 5 using Tapatalk
 

PimpleX

Full Member
Sep 16, 2012
44
0
The other obvious requirement on a hitachi is that the laser be able to read the disc before it is able to go mode b.
 

turny

VIP Member
Mar 17, 2010
104
0
#JungleFlasher
The other obvious requirement on a hitachi is that the laser be able to read the disc before it is able to go mode b.
incorrect, modeb is a portio command over sata
you can modeb a hitachi logic board without
anything attached other than sata and power,
you NEED working laser for unlock79 audio disc
NOT modeb.