POGO MO THOIN Home made probe questions.

[Ramzinho]

Sub guys. i managed to make a PMT but now i want to add some touches to it. i wanna use a 6pin push button and LEDs.

so that the LED is on when the circuit is on and Off when circuit is off.

and i want to add a green led to when i ground MX01 point.

Here is what i know:

• i know the basic diagram
• i know that the LED longer leg is +ve

What i dont know:

• • how to connect the Red power led
  • how to connect the Green Earth LED
  • and which pins should i be using in my 6 pin switch.
  
  
  

 

[Urban Gamer]

Just put the LED in series with the wire so you know when current is flowing through it.

 

[Ramzinho]

ok what about the switch pins. i don't have a multimeter to know which pins connect power. could you know?

 

[sp4rkst4rt3r]

Can you re-post the original picture showing the equipment you are using (i.e. the equipment the drive power cable is connected to)....my guess is that you aren't using a TX product and that is why you changed the picture....

 

[TechTona]

connect the wires to two continuous pins[column way not row] .

 

[Ramzinho]

i used batteries + LED to know which pins pass power on the switch and i'll connect the LED for that in series.

What remains here is how to connect the LED on the GND+Probe to make it turn on when i touch the MX01 point

 

[XBOX4LIFE]

This is a Team Xecuter support forum dude, looking at your first pic you are clearly using non TX product..
I would recommend you try the support forum for your equipment or buy better tools
Closed