LITEON 9504 How do you put Unlocked TX PCB in Vendor Mode

[Plutonian78]

Hello,

under jungle flasher

MTKFlash32

I want to put my unlock PCB in Vendor Mode

says no drive detected, is that because the controller is empty of no firmware, present.

 

[Rome 16:16]

Intro the drive then power cycle

 

[Tech9xt1]

Theres a tip in uber's guide.
click Liteon-Erase and power cycle - you should then get into vendor mode (0x72) with no problems.

 

[playingmax]

"Tip


If the TX Unlocked PCB doesn't detect at all and you can't get into vendor mode with the above method simply click Liteon-Erase and power cycle - you should then get into vendor mode (0x72) with no problems."



http://team-xecuter.com/forums/showthread.php?t=67582

 

[Plutonian78]

I will try that playingmax, cause the pcb tx unlocked says no drive detected.

my xboxusbpro has one green light and one red, and the ck3i has red , yellow and green

 

[Tech9xt1]

Did you install the Usb Pro drivers ?

I've got 2 green & 1 flashing blue.

 

[Plutonian78]

not working still says 0x80, no matter what I do

---------- Post added at 14:40 ---------- Previous post was at 14:37 ----------

Yes Lattest drivers 0.18 executer x360usb pro drivers installed and running jungle flasher 0.1.91 Beta(300)

and ck3i pro drivers are installed as well

---------- Post added at 14:49 ---------- Previous post was at 14:40 ----------

think is the CK3i drivers. I think I have removed them

 

[Tech9xt1]

And the unlock switch on the TX board is set to WP1 ?

 

[Plutonian78]

all drivers are installed, before I start up the jungle flasher

I connected the unlocked pcb tx to xboxusbpro and ck3i and the xbox usb pro has 2 green light on and the blue light fflashing

and the ck3i has a yellow, green and red light.

now I'm turning on jungle flasher

---------- Post added at 15:01 ---------- Previous post was at 14:59 ----------

the switch is set to wp-1

 

[Tech9xt1]

Go to step 8 - 9 of the Guide.

http://team-xecuter.com/forums/showthread.php?t=67582

 

[Plutonian78]

think the unlocked tx might be faulty

as it says no drive detected on MTK flash 32

 

[Tech9xt1]

Make sure you have fat selected.

When you have everything loaded & ready to write, try intro & then just press write then the board might show up.

 

[Plutonian78]

Thank you so much

It worked, done just what you said and it was recognized, in vendor mode

than flashed to 272

Perfect

---------- Post added at 19:51 ---------- Previous post was at 19:51 ----------

If you ever come to newport, Wales, ,msg me and I will buy a drink

 

[Tech9xt1]

Nice one

Glad you got it going mate.