READ!: Before you do this i can only help for people Who DO NOT HAVE the J-tag programming cable with their nand-x!
How to fix the following: Failed with 0x0002 status error.
1. Check your soldering, Make sure non of the solder is touching any other wires!
2. Make sure your nand-x Programming wires look like this: http://i.imgur.com/U0xU8.jpg - Ignore the 18,19,20 BUT You would need to know where they go on the coolrunner like TDO wire etc.
3. If everything looks like that picture and everything is all connected to coolrunner you should not have ANY problems.
If you do have any problems and my post didn't help just leave a reply and ill hope to respond A.S.A.P.
Thanks.
How to fix the following: Failed with 0x0002 status error.
1. Check your soldering, Make sure non of the solder is touching any other wires!
2. Make sure your nand-x Programming wires look like this: http://i.imgur.com/U0xU8.jpg - Ignore the 18,19,20 BUT You would need to know where they go on the coolrunner like TDO wire etc.
3. If everything looks like that picture and everything is all connected to coolrunner you should not have ANY problems.
If you do have any problems and my post didn't help just leave a reply and ill hope to respond A.S.A.P.
Thanks.