GENERAL How to fix Nand-x after accidental power on?
- Thread starter Dimrain13
- Start date
If you just want them as stock systems when you are done you can re use the coolrunner over and over again if you soldering is up to par. You don't need to leave it glitched after you have the CPU key. Depending on your CB and motherboard jtag/rgh1/rgh2 would be the only methods you need to use. R-jtag is for awesome boot times etc but not needed for just a key should be able to grab it with a rgh2 method (unless it is a xenon/zephyr then ...r-jtag for zephyr but the xenon / zephyrs may not be worth the hassle up to you ....:smile:
Last edited:
=D awesome, that I needed to know for that thank you,
You mean by this,
I exploit the console, then get cpu key, to decrypt the nand get all info I need flash back to stock undo the exploit and remove wires,
use info to flash drive and its done?
I can resue the jrunner and chips to do this on the next
?
If this is true, then exaclty this I wanted to do and keep 2 jtags 1 as backup and 1 for play and programming
goodday guys =D
You mean by this,
I exploit the console, then get cpu key, to decrypt the nand get all info I need flash back to stock undo the exploit and remove wires,
use info to flash drive and its done?
I can resue the jrunner and chips to do this on the next
?If this is true, then exaclty this I wanted to do and keep 2 jtags 1 as backup and 1 for play and programming
goodday guys =D