RGH How to fix No Green Light on Coolrunner

[Leussink]

Hi,

I installed my QSB on my slim correclty and read my Nand very well, no problems at all.

But after the QSB my problems begin. I broke my POST_OUT point and used the ALT point from the stickied post.

Now if i try to turn on my device i got no green light on my coolrunner its only red.

How can i check if my solderings where correct?
Or do you guys have other solutions?

 

[seanr28]

Have you written the ecc file to the nand? if not the green light wont flash until you do

And just to be sure, you have flashed the cool runner with the relevent file??

 

[Leussink]

Have you written the ecc file to the nand? if not the green light wont flash until you do

And just to be sure, you have flashed the cool runner with the relevent file??

Yes the ecc file is on the nand and my coolrunner got his files on it.

Is there a way to check de soldering from me?

 

[seanr28]

post some pictures

 

[Vwracer69]

The best thing you can do is post pictures of both the install and the repair you said you had to do. the one thing i can tell you is that my RGH i did on a falcon gave me problems. i checked all my points with a meter and everything looked good but no green light.finally got frustrated and pulled all the wires off and re soldered everything and BAM,it worked.

 

[Wgr73]

I suggest pulling off the QSB and solder directly to the pads and see if that works. R3B15 is a very hard point to get with the QSB