so i've been flashing for years and finally decided to r-jxtag my box after buying an xbox one. i bought the qsb kit, soldered everthing in and it didn't work, kept getting a version 10 0x0000 error or something in jrunner. while i'm good at soldering, i never really had to go back and unsolder chips so small and well long story short, i'm pretty sure i damaged the first one while taking it back off. i have a few other 360 laying around and i want to r jtag another one, its a falcon like the one i started with. i can't find any guides on how to straight wire the cr4 xl to the board, all the ones i see is with qsbs. is it possible and if so i would greatly appreciate a link to guide on how to do this.
how to r-jtag without qsbs
- Thread starter daqid
- Start date
You either need to use the diode method or the transistor method . It's the exact same method as doing a JTAG. Your just adding the CR4. You also have the choice of doing RGH with the CR4 with less work but it may not perform as well. But then again, it may perform just as good.
And FYI. From here on out, Google is your friend. It would be a lot easier for you to google "how to JTAG my xbox". Find you a good guide and then come back here and finish the process by following a guide on the steps to install the CR4.
Last edited:
all you need to do is follow the cr4 install guide plus the link krafter gave you for the wire install without qsb's that's it , forget the diodes
Thanks was just on my way out to get some. I'll start on it in a few and let y'all know how it goes.
