I think it messed up writing ecc to nand because when i turn on it hangs at the green light and gives the chime but doesnt boot
RGH How to write old nand on corona.
- Thread starter brent1wer
- Start date
Utmad
VIP Member
Fill in RGH template in my sig for support.I think it messed up writing ecc to nand because when i turn on it hangs at the green light and gives the chime but doesnt boot
TX Product(s) used:TX 4gb nand
Console type is corona
NAND size:4GB
Dashboard version: e.g 2.0.16756
Screenshot of NAND details from J-Runner: It was yesterday and it said everything was susuessful
Description of problem:I created the ecc then flashed it to nand then it turns on with a green light and hangs and theres no rol
Was the console working before you started: y
Console type is corona
NAND size:4GB
Dashboard version: e.g 2.0.16756
Screenshot of NAND details from J-Runner: It was yesterday and it said everything was susuessful
Description of problem:I created the ecc then flashed it to nand then it turns on with a green light and hangs and theres no rol
Was the console working before you started: y
Last edited:
scott1503
VIP Member
ECC won't give the roll. green light (on the power button) should stop blinking, that's all.
Then you should get cpu key using LAN or through HDMI (not sure if your ecc supports video output)
Then you should get cpu key using LAN or through HDMI (not sure if your ecc supports video output)
Omg. Thanks i didnt know with coronas that you have to get cpu key over lan. But my cr light flashes green forever and i played with jrunner and found out how to write old nand back and boots. im leaving right now so could you tell me if the blinking cr light forever is normal or does it just keep blinking even in xell but thx for the answer 15432
ultimate360
VIP Member
Well, the corner of that CR that we CAN see sure looks genuine, that printing seems too clear to be fake too, but we need to see your whole setup with a perfect view of the chip.
jsinger47
Troll Eating Dogs
You must be a bit behind the times, my friend.
Xell fully supports coronas now, unless there are bugs with the winbond2k ones.
I tried 2 diffrent ones. Whats the one you have had the best luck on and my cpu rst is wrapped around my xclamp is this good or bad boot times
Checked right now
JRunner ECC files contain XeLL Reloaded 0.993, with full video output support. Both HDMI / Analog video should work
actually, there's a bug causing total freeze if you have Hitachi drive (that was fixed in 0.994)
jsinger47
Troll Eating Dogs
It's been a while since I've done a glitch with a CR3 Lite but if memory serves me I started with file 2-3 and worked from there. There may be more than that though. Some Corona's you have to jumper a couple of missing resistors and/or use a post fix adapter. What version of mobo do you have? V2, V4 or V6?
I have a corona v4 with the post-fix adapter installed and i bridged the jumpers for the r/w are there anymore i need to bridge?