http help

[SU8ZERO]

i have installed an x3 into a v1.1 xbox and im trying to flash it via http through a netwrok card wen it press enable networking at the flashbios screen and it goes to the failed to intiliaze falling back to 192.168.0.99 wen i type http://192.168.0.99
into address bar says page cannot be displayed.how do i fix this problem?wat led on the bank switch should be on or flashing?

 

[sb122606]

Havn't u posted this question b4??
so u have a cross over cable between them...right??

you have to set up you network card to be in the same broadcast domain..

assuming winxp
start/control panel/network connection
right click on local area network and select properties
double click on internet protocol (TCP/IP)
ip address 192.168.0.5
subnet mask 255.255.255.0
default gateway 192.168.0.1
the click ok and reboot..
disable firewall and ping yourself 192.168.0.5 u should get a reply..once thats right u should reach the xbox on 192.168.0.99.

switches should be set on,on,off,off,off if its the old control panel
if its the new panel then set off (red),on (blue),on (blue) ,off,off

 

[SU8ZERO]

i have posted this b4 but it was for a diff chip

 

[sb122606]

ok ..so what happens then when u ping yourself or ping 192.168.0.99 (once it falls back to default)

 

[SU8ZERO]

wen i did that i flased it now im jw how to load unleashx on it
i have a disk so im gonna try that
but its scratched so how do i put unleashx on the bios without a disk?

 

[sb122606]

you just ftp the extracted files to c:

two folders ..media & shoutcast
and two files avalaunch.xbe & avalaunch.xml

then go into CFL and configure dashboard boot ootion to put avalaunch at the top

 

[SU8ZERO]

ok all i got was ftp
go to c:
wat files do i put in the c: drive
after that wat do i do
i flashed the chip with x3_3029

 

[Darkpaw]

Avalaunch.xbe goes on C next to xboxdash.xbe