I can Write ECC to the NAD but no No glitch light at all

[kao_solid]

Hello,

I nedd some help here

I have everything installed but when I try and boot into xell to get my cpu key, it won't boot black screen. Also, no light at all in the CR4XL.

I can dumb the nad and I can Write ECC to the NAD. Although, I get block err but from what I understand it will remapped so no problem here.

When I failed to get into xell I returned the original nad the Xbox boot and the logo came out.

I put some pictures for my soldering for the blue and yellow cable I didn’t put picture because I returned back the x clamp. But I review it many time no problems.

 

[BrockThunderjam]

Some of your solder joints look cold, particularly at the QSB. Did you use flux? You may want to add some and hit it with the iron again. Also, what dip settings are you trying? And please clarify if the console does boot back to stock without any issues? When you say no light at all on the CR4 do you mean the 5V light isnt even on? If so your QSB soldering is probably the issue.

 

[rghpro]

Did you check the CR4 box in Jrunner before creating the ECC?

 

[rghpro]

@BrockThunderjam

His soldering is poor/moderate at best, but I think that even at the low quality the soldering is, the cause may be something other than mediocre soldering, but I may be wrong.

 

[kao_solid]

Some of your solder joints look cold, particularly at the QSB. Did you use flux? You may want to add some and hit it with the iron again. Also, what dip settings are you trying? And please clarify if the console does boot back to stock without any issues? When you say no light at all on the CR4 do you mean the 5V light isn't even on? If so your QSB soldering is probably the issue.

• Yes, I did use some flux. Regarding, the dip switch 3$4 on the rest off.
  
• Yes I return the console back to stock and it did boot with no problems.
  
• For the light Yes it's not even on. No red light or green.
  
• I thought since I can write to the nad that's mean my QSB soldering was o.k. I am thinking if that the case I will get ride off the QSP and connect the x-nad cable directly to the point it's much easier to soldier.

 

[kao_solid]

Did you check the CR4 box in Jrunner before creating the ECC?

Yes, I ckecked that . In the begning I forgot the second try I checked the CR4 box.

 

[bruno_rv]

I would say soldering problem. If you dont even get the red led on,then soldering must be your problem

 

[nofeloniesyet]

I would say soldering problem. If you dont even get the red led on,then soldering must be your problem

5 volt wire dont look to be soldered very good,it looks like its def making contact,but def need to get the solder to flow onto that wire better.

 

[keil423]

You could also stand to trim the end of the green wire down and shorten your yellow and blue wires. First resolder your power wire at the qsb.

 

[kao_solid]

Hi:

Finally I succeed and every thing went perfectly. it's like what you said guys bad soldering.
I just removed the QSP and solder directly to the point. It's not necessary what I did was the right way to go but it was easier for me to solider without the QSP.





I am grateful for every body who help in this thread and special thank for Team Xcuter.

I wish all a wonderful day.:wink:

 

[ablegepu]

great. It was definitely the red wire not getting 5 volts it needed then.