RGH i got a issue

[x360ccm]

i no the rules i post pics of the repair i done on this console.

and it not my soldering.i can say that.

i done this repair a few times.

but this one is a pain in the rear end.

i no the freeboot image is fine.

the ecc is fine.

i even put the retail nand back on it and it boots fine everytime.

i thinking i left the repair wires to long on this plus it.s a jasper small block..

it booted a few times i run it for 2 hours or so playin a game no freeze up or nuffin,

but i damm if it will work all the time.

i no it's the way i got the green wire but i cant get it 2 that spot.

on a falcon i did the other day i had no issues like this.
any addvice you pros plz.:facepalm:

i up the pics of the repair in mornin,

 

[BL4K3Y]

So what you are saying is the console will only boot once in every few attempts?

 

[x360ccm]

yes you hit the nail on the head.

this pic is of a falcon repair the other day.yes it's a 10k resistor.

and this work spot on.

like i say this repair is done the same way.but this is a jasper.xclamps intact.

 

[BL4K3Y]

I assume you added cable shielding on the Jasper too?

If so, try removing it as this was only an alternative fix for consoles that wouldn't boot otherwise.

 

[x360ccm]

here is the repair of the jasper.and no the green wire aint runnin over the blue wire..

i moved all the tape of to take the pic.

 

[x360ccm]

i got a up date on this.i got it booting in 1 or 2 flashes of the cr.

i redid my fix on it like in the pics.

now this is the resistor i use on the strip board 110785972222.

it booted fine.

worked for 7 hours of game play.i boot it up this morning and the cr dont flash.

i write orig nand.i got 0022.

now i thinking the way i done it now i fugde up .

but i removed it resistor checks out.i redid like in other pic and the same.

from what i read i think cpu dead.

as it about 5 seconds then rrod.

grrrrrrrrrrrr