LITEON DG-16D2S I Got A Problem - The Flashing Green Light In The Middle

BranstonProject

Full Member
Jan 3, 2012
52
0
have you plugged it in the right way.
and as blakey said are you 100% its not blank.
Yeh The right Way And And No Its Not Blank

---------- Post added at 20:44 ---------- Previous post was at 20:43 ----------

It sounds to me like it has no firmware on it.

Do you have dummy.bin?
Theirs Firmware And Yeh I Got Firmware
 

BranstonProject

Full Member
Jan 3, 2012
52
0
Explain step by step what you did.

Lite-On erase is the only way to get phat Lite-On drives into vendor mode.
1st ) Open "jungle flasher" when my xbox connect and gone to "MTK Flash 32"

2nd) Do A "Intro / Device ID"

3rd) Then liteon erase

4th) Gone to the "firmware tool 32"

5th) Loaded My Dummy with My Key On the Top Half And The Liteon Original Then "Spoof Source To Target

6th) Then I Went To the "MTK Flash" And "write"

7th) Then I Did the "Outro/ATA Reset"

6th) Then Turn xbox On Flashin Light :(
 

BL4K3Y

VIP Member
Jul 7, 2010
12,860
118
Colne, Lancashire (UK)
Why did you Intro the drive before-hand?

Load your firmware .bins in the appropriate buffers (FirmwareTool 32), run Lite-On Erase, click Yes twice, power cycle, click Write and finally, click Outro/ATA Reset.
 
Last edited:

Loomingx

VIP Member
Oct 19, 2010
250
0
Canada
Probably got 2 bad Fleabay drives. Do you have any known working drives you have that you can temporarily spoof to your console to isolate the problem?