i have a xbox 360 jasper with rgh2 but my boot times were really bad more than 15 glitches. i followed some videos but they use a aud_clamp for qsb i dont have any qsb's at all i know its a headache without qsb's but can someone point me to some diagrams with no qsb's i cant find them. ive found so many guides but they all use qsbs which i have not purchased and not found to purchase. Can someone one point me to some diagrams please for r-jtag no qsbs at all?
I need help to find wiring for r-jtag for jasper with no qsb's at all
- Thread starter Cokeaholik
- Start date
GeekHeat
VIP Member
I have the cr4 xl chip im trying to rgh2+ again with a cap installed on the chip see if that works ive read that works.
GeekHeat
VIP Member
this is the thing when i connect the jr-programmer to jr-runner i get that its either a jasper 16mb or trinity so when i write nand with trinity the system wont turn on. I write nand as jasper 16mb i was getting boots before but now wont reboot at all. Now the DB1F1 point just wont work so i soldered to alternated point underneath (FT1U2). XBOX still wont boot. I have a 10 cap installed and have tried all dip switch configurations and jumper settings still not getting it to boot.
- - - Updated - - -
the xbox still tries to boot just keeps glitching.
- - - Updated - - -
the xbox still tries to boot just keeps glitching.