I toasted a Rebuild point!!! HELP PLZ
- Thread starter jizza_69
- Start date
Vol4Ever
Full Member
Sorry I can't help, but I'd love to see a larger picture of your background diagram. I had the same problem with the red wire.
thats just a pick i got from the install guide.... and edited to show the point i fried.....
HELP!!
HELP!!
try following that trace to see if there's another solder point on it. If not, you can try to *very* carefully scrape part of the trace with an xacto knife to expose the copper and then solder to that.
Vol4Ever
Full Member
metalgear
VIP Member
Vol4Ever said:
Go here and scroll down you'll find it there
http://www.teamxecuter.com/x3/tutorials/x3pin16.htm
Vol4Ever
Full Member
OH. That's a v1.6 install. Is there a similar diagram for v1.0? My LPC got fried, and I'm looking for alternate solder points on the mobo.
i screwed that point as well there is another solder point south west of it, however you will not beable to get to the MS dash until you rebuild that trace
@trubored
Thats what i was afraid of....because i am fragging with the chip off....dang it.... anyone know of a work-around?
can you still set the clock without the M$ dash with a 2.6? .... i guess Avalaunch will do it....
I am good.... but if someone could tell me what to solder together to get the M$ dash back that would be great.... I mean I can run a wire from the top of the mobo to the bottom.... if thats what it takes....
???
Thats what i was afraid of....because i am fragging with the chip off....dang it.... anyone know of a work-around?
can you still set the clock without the M$ dash with a 2.6? .... i guess Avalaunch will do it....
I am good.... but if someone could tell me what to solder together to get the M$ dash back that would be great.... I mean I can run a wire from the top of the mobo to the bottom.... if thats what it takes....
???
just follow the trace up past it and see if there is a solder point, if there is, just connect the 2 with a wire and it should be good, i honestly don't remember if i looked for one above where i screwed up, however i don't use live so it is not a big deal to me
Followed it to the top of the board.... rebuilding there doesnt work...... the lead on the bottom goes to the chip.... am i hosed??