ANSWERED Identify my Corona Version!

[Enigma Solo]

My Torx T8 isn't big enough to get past the 'x' panel.

Here are a few pictures, i'm 99% sure it's a v1.
If you can make comparisons with these parts of the Corona and check it's a v1 then please do.

Cheers,

Link to all images:http://m.imgur.com/account/EnigmaSolo/images

 

[Martin C]

Was the 'Xecuter official Corona identification guide' not clear enough?

 

[Enigma Solo]

It was perfect, but getting into the xbox further than this is an issue for me. I'm not asking to be spoon fed here, i'm simply asking others if they can help me identify it since they may know what a v1 corona motherboard looks like compared to a v3.

 

[scott1503]

Your imgur account is set to private

 

[Enigma Solo]

Nand, resistors, etc can show the differences between corona board versions and i understand that. But what's visible here could possibly help me find out. If you have any clue whatsoever then please post below.

 

[Enigma Solo]

Changed to public ^^^

 

[Steel-Cleiton]

still can not see the pictures
File not found message
make it right so we can help you
nobody here has time to be losing

 

[Enigma Solo]

All images appear perfectly fine for me, no worries. i'll spend an extra fiver on a POST if it turns out to be a v3

 

[scott1503]

Permission denied still

 

[Oggy]

They would appear fine for you, you're probably signed in

 

[Enigma Solo]

Closed tread, accessed nand and resistors, confirmed v1