Hey guys, i know this is my first post. But i wanted to start making JTAGs but i am seeing a couple different ways. Is NAND-X only for dumping your NAND? Or is it for making the whole jtag? And once you use nand-x once, what do you have to buy again?
Im Kindof a Noob, Does NAND-x ONLY dump your nand?
- Thread starter Puurplez
- Start date
sick360mods
BANNED
the nand x is used to dump and write to the nand. the jtag parts also come with the nand x but only 1 so u will have to buy more from a reseller.
Ok thanks guys, Im still trying to find out how im going to do this. If you could help me, AIM would be AMAZING!
J2G
VIP Member
What ever way you decide do it you will need the Nand X to read & write to your nand for an easy life.
You can use it over and over again on any Jtag well worth the buy i say
I know that, but like what parts do you have to buy AGAIN. Because the set only comes with enough for one motherboardWhat ever way you decide do it you will need the Nand X to read & write to your nand for an easy life.
You can use it over and over again on any Jtag well worth the buy i say
It's the actual JTAG parts you need to buy again. Like the JTAG QSB's, pin headers or diodes with wires that was mentioned above.
You only read and write the NAND with NANDx. You should not mix the NAND and the JTAG part together too much.
There's a great guide here:
http://team-xecuter.com/forums/showthread.php?t=54423
You only read and write the NAND with NANDx. You should not mix the NAND and the JTAG part together too much.
There's a great guide here:
http://team-xecuter.com/forums/showthread.php?t=54423
J2G
VIP Member
It all depends on what mother board it is and what way you are going to do it, but if your new to it i'd go with Xecuter NAND-X QSB Install Kit these will connect the Nand X for read and write on any board.
If your going to be using QSB then all you need is here JTAG Products if your going to be using wire & diodes then you will need to read up on it its a bit more trickier.
sick360mods
BANNED
J2G
VIP Member
As i said it all depends on your exp like your soldering if its bad then you can be at it for a while and getting nowhere, nastybrother24 that is why i said the QSB a persons first time doing direct wiring idk about that one buddy i have seen some messed up Jtags and so have you lol