ImgBurn error???

[jwmghf]

Hey guys:

Imgburn just gave me this error:

Device [4:0:0] ATAPI iHAS124 B ALOS (D) (ATA)

Scsi Status: 0x02
Interpretation: Check Condition

CDB: 2A 00 00 20 3A 60 00 00 20 00
Interpretation : Write (10) - Sectors 2112096 - 2112127

Sense Area: 71 00 03 00 00 00 00 0A 00 00 00 00 0C 00 00 00 00 00
SK Interpretation: 71 00 03 00 00 00 00 0A 00 00 00 00 0C 00 00 00 00 00
SK Interpretation: Medium Error
ASC/ASCQ Interpretation: Write Error


Retry or Cancel

The dvd burner is an Lite-On Ihas124 b with the proper f/w for this application.
The dvd is a Verbatim 8x DL
I am running ImgBurn 2.5.7.0 and Windows 7
Let me know if you need any more hardware info.

----------------------------------------------------------------------------
I ran the game through ABGX360 and everything checked out ok. I
It looks to me like the layer break is what failed. I was trying to backup "KINECT RUSH - A Disney PIXAR Adventure". Do you think it was a bad disk. I just don't want to waist another DL disk if I don't have to. In Tools/Setting/Write everything is set to defaults except for "Perform OPC Before Write". I have this checked. Under options for "Layer Break" it is set at "Calculate Optional". I was told that these settings should be fine for my particular setup. What do you think??

Thanks

 

[hersheys247]

Sometimes you have to go through some coasters before you find the optimal settings, each setup is differently


If i helped you in anyway, please press the THANKS and REP button

Sent from my brain tumor causing device using Tapatalk

 

[jwmghf]

Well here's how I got it to burn sucessfully. I unchecked "Perform OPC Before Write". Will that effect if the disk will play or not??? (I can't test it until tomorrow.)

 

[Disk0]

have a read of this thread here - http://www.team-xecuter.com/forums/showthread.php?t=74721

I don't use OPC before write and get good burns

 

[jwmghf]

.

 

[jwmghf]

Good to know Disk0. I didn't know if it was mandatory to use that setting. I was thinking that maybe the disk would burn successfully but might not play the backup. I will try the burn out this afternoon and see if all is well.

Thanks

 

[jwmghf]

That's a great guide!!! There are however a couple of things I don't get... When they say to power cycle the drive, does that mean re-boot my computer?? If not, what does it mean? And also, where will I find the EEPROM settings they are talking about??

Thanks

 

[sherlock]

read here http://team-xecuter.com/forums/showthread.php?t=73745 :wink:

 

[jwmghf]

Thanks Sherlock:

I looked around forever in imgburn to find the settings that you guys were talking about and I finally found them. I then proceeded to adjust my settings to the recommended ones and try the Verbatim mkm003's and it worked successfully!!!! Now I know where most of the settings are done, but I am still wondering about, "Power cycling the drive" is all about, but I bet the guide you just pointed me at is clear that up!

Thanks and Happy Easter!!!