install difficulty with x2.6ce lite and xodus sp solderless adapter

[halcyon22]

i am tryin to install my modchip into my v1.4 xbox and im trying to seat the xodus adapter that works with this modchip, but im tryin to figure out where to place the template that came with this adapter...

http://teamxodus.com/pictures/Manuals//S.P.pro.pdf
on this manual at the bottom of page 3 it shows the template seating nicely on some xbox labeled IC chip, i cannot find that chip in my box and i need a way to seat that adapter so i can install the modchip properly..., if i cant get around this then i need to know where the LAD3, LFRAME, LAD2, LAD0, and LAD1 connectors on this adapter go into the board at.....

any help is greatly appreciated!

p.s. this manual is the closest i could find to match the adapter i have, they look very similar so im assuming they are the same!

 

[DJBOOBY]

over your shoulder it only used for v1.6 xbox as well as the part that has the wires and lights you just need the standed solderless you just spent alot of money on a solderless that you dont use all the parts

ps there are two spice solderless adpters one for the that other sh*t chip and the universal one for x3 x2 chip hope you have the right one

 

[halcyon22]

i just got a message back from the divieno tech support....

"We do not carry this solderless adapter anymore.
What we sent you is the generic adapter, which is better than the one you ordered."

They dont carry the adapter in the ad, and they sent me a xodus sp solderless adapter, apparently (according to them) this adapter will work just fine on my box, but i have no idea what to do with the extra wires, the LADS that is.
So, could you send me some links showing me what solderless adapter i need or how i could install this adapter into my v1.4 xbox.

Thanks!

 

[DJBOOBY]

ok in the spice guide it show how too plug the black adpter with the screw hole and the one wire to the bit with the 4 wires as well as lights you do not use this part the rest you toss as well the spice is for the v1.6 only xbox this is what they don,t tell you.

http://www.teamxodus.com/pictures/Manuals/Solderless%20Install%20Manual.pdf
you just do a solderless install but you have to make shore that the solderless has the same number of pins as 2.6 pin head
not shore this is all the right way but pritty shore